Work with us today
For more information on our products, services, and solutions, and to get pricing, please click on the button below.
Download files to the pc here. You may receive a warning that this file is not downloaded often. Choose to keep…
If the plasma or table stops, you may need to restart the cut halfway through the program. Note before you…
To use the UC100 parallel port to USB driver you will need to make the following settings changes: Open Config…
For your CNC Plasma Cutter to cut accurately, the motors need to be tuned. Basically, this means that every pulse…
Mach3 Update Please update Mach3 to the latest version available, instructions are as follows; Download this file to your pc Mach3.exeYou…
1: Make sure wires are connected on the Torch sensor. Test for continuity from switch to controller. Test for break…
If the controller does not have a UC100. Go into device manager. Try these two settings in the ports and…
This issue is usually caused by the Torch Sensor switch either not physically engaging with the linear slide or due…
Ensure the black cable is connected to the UC100 and is plugged into the USB port on the computer. Also…