How often you need to change the consumables on your Powermax 45/65/85/105/125 will depend on a number of factors: •…

We’ve created a template for the most common materials and the settings you will need to cut using the Hypertherm…

If you are getting 0-30 error on the LCD screen of your Hypertherm Powermax plasma cutter follow the recommendations below…

Ensure the black cable is connected to the UC100 and is plugged into the USB port on the computer. Also…

This issue is usually caused by the Torch Sensor switch either not physically engaging with the linear slide or due…

If the controller does not have a UC100. Go into device manager. Try these two settings in the ports and…

1: Make sure wires are connected on the Torch sensor. Test for continuity from switch to controller. Test for break…

Mach3 Update Please update Mach3 to the latest version available, instructions are as follows; Download this file to your pc Mach3.exeYou…

To migrate your Design Edge licence, or reactivate it on another PC, you will need to request that the licence…

TEST 1:Turn off the power Remove the Z-axis motor. Loosely reattach just the motor body using two opposite bolts. Hold…

TEST 1: Measure the motor resistance through these two terminals on the motor wiring harness. The resistance should measure between…

TORCH HIT MATERIAL DURING MOTION ERROR RESOLUTION If you are getting errors message saying “Torch hit material during motion” when…

COMMUNICATION ERROR RESOLUTION Communication Errors in DesignEdge can be incredibly frustrating to troubleshoot. Below, we’ve made a list of the…

Check if the SheetCam software is registered and licensed. Go to >Help then >About.

Cutting rules in SheetCAM are a powerful way to fine-tune your cutting results. You can add a ruleset from the…

We’ve created a template for the most common materials and the settings you will need to cut using the Hypertherm…

Setting the part origin in SureControl CNC Plasma software.

Using SureControl to reference (or ‘home’) you CNC plasma machine, and correcting wrong referencing direction.

How to turn on THC in SureControl, and when should you use it.

Setting the cutting parameters in SureControl plasma software.

How to perform a ‘dry’ or ‘simulation’ cut in SureControl without firing the plasma cutter.

Setting the part origin in SureControl CNC Plasma software.

Using SureControl to reference (or ‘home’) you CNC plasma machine, and correcting wrong referencing direction.

How to import a DXF drawing file into SureControl Pro.

How to turn on THC in SureControl, and when should you use it.

Setting the cutting parameters in SureControl plasma software.

How to relieve tension in the hose reel on a Dragon A400 Tube Cutting Plasma.